One of the preparatory stages of the car is warmed beforehand. If over time, let sit in a car that is fairly warm conditions. Do not do when a hot engine conditions. It would be quite dangerous. But do while conditions have started to warm, this is the most appropriate conditions.
Once the car is warm enough, cover some of the components that support the engine ignition system, such as distributors or delco, alternator, starter dynamo, spark plug wires and existing electronic systems in the machinery sector. You can just close it at will, provided that sufficient meeting and also not until translucent water. For example, you can use plastic or aluminum foil.
After the above preparation was in order, time to do the spraying. The first part to be sprayed is the side of the hood. After the new iu continued on the walls of the machine. To clean it completely, just use a dab of soap existing ordinary on the market. Besides low cost, a dab of soap is very suitable to shed impurities such as former oil.
If everything is rinsed with water, immediately dry with a clean dry cloth. Do not let any residual soap that sticks because it would leave a mark. Next, start by cleaning in the engine room.
Moisten this first part with the water pressure is not too high. Point, so that certain components are not soaked and cause damage. When cleaning in this section, use a sponge or cloth used for parts that are accessible. whereas, for the slightly difficult, can also use a brush rather rough surface.
After all finished, do not forget to always clean it with a towel or cloth to dry and clean. Make sure each interrupted, not lagging to prevent water from corotion.
No comments:
Post a Comment