How to Eliminate Scratch In Glass With Polish

Glass Scratch certainly common in your vehicle . Usually this happens because of dirt on the glass when swept wipers swipe . To overcome these scratch then polishes it is needed , not only removes scratches , but also provide protection for vehicle glass .

Polish glass can actually be done in the workshop , but you can also do it yourself to get more satisfactory results as you see fit .

The first thing needed is to prepare materials and equipment for polishing . Prepare cerium oxide glass polishing powder that is to be had in shops polishing equipment . Next prepare fine sandpaper and polish pad made ​​from ' Felt ' . Jjika you have tools such as a drill can be used to simplify the process of polishing .

In order to polish pad mounted on a drill , buy backing pad measuring 3 or 4 inches which can also be found in the store fixtures polished . Then prepare a water spray , chamois cloth , or paper tape and newspaper .


Polishing windshield

Here are the steps in order to brush up on your windshield scratches disappear and appear sparkling clean .

1 . Clean the glass surface with water and wipe . Then check the section that uses your finger nail scratches . If the scratches are deep enough , you will be able to feel your nails snagged . Take a fairly fine sandpaper , then sand the parts that are soft scratch cutting direction so as not to damage the glass .

2 . Clean the parts that have been sanded back using water and a cloth . Then tape the edges of the glass to protect the body . If necessary to protect the body using newspaper or paper protector . Fluid that dries polish stains can be hard to clean and can even damage the body paint .

3 . Melt the cerium oxide glass polishing powder using clean water . Use enough water to get a medium consistency . If it is too liquid , the abrasive nature of the powder to be low so that the polishing process can be long .

4 . Attach the backing pad is mounted on the drill pad polish . If you do not have a drill , could use a hand . Then rub the pad with liquid glass and cerium oxide , then start polishing in a circular motion .

5 . Do not polish too long on one section , do the movements slowly to all parts of the glass . For part of the scratch , give emphasis to eliminate blurry because the former had been sanded . When polishing spray water so the glass does not become wavy even cracked due to heat from friction .

6 . Perform polishing glass to scratches fade , add liquid cerium oxide if it is considered exhausted . After polishing is complete , wipe the glass with a chamois cloth to appear clean and shiny .